Emissions
Emissions calculated from the plant, not from invoices.
Flow, fuel, power and process values from your PLCs, meters and sensors become Scope 1 and 2 emissions, calculated as the site runs, with every figure traced back to the tag that produced it.
01Traced
From tag to reported figure.
- QuantifyActivity data read from SCADA, PLCs, meters and sensors, not estimated from bills.
- CalculateCombustion, flaring and fugitive emissions, recalculated as the site runs, following GHG Protocol methods.
- TraceEvery CO₂e figure links back through factor, method, measurement and source tag. No spreadsheet in the path.
From PLC tag to CO₂e
Example: boiler fuel gas at one site, from the source tag to the reported figure.
| Step | What happens |
|---|---|
| Source tag | FT-101 boiler fuel-gas flow, read from the PLC |
| Activity data | Volume, unit and timestamp aligned by the platform |
| Calculation | Fuel volume × emission factor for the measured gas composition, from a versioned factor list |
| Result | CO₂, CH₄, N₂O → CO₂e, rolled up by asset, site and period |
BOILER-01, current periodScope 1, traced to FT-101
1,284.7 kg CO₂e
Illustrative values.
Where are your sites losing value today?
A focused first engagement, measured against your own baseline.
- We map your first sites with your team. Each new site reuses that mapping.
- We agree one outcome and a baseline to measure against.
- We connect read-only and check every signal against your HMI.
The assessment is a fixed-scope first step. Your first site shows results in 2 to 4 weeks, and you decide on rollout after you see them.